8 thoughts on “ Readin The Meters ”

1. Tojasho says:

   19.12.2019 at 13:48

   Comment by Nexus Geological Reading - 28,28 Southern Coldarra Reading - 28,34 Northern Coldarra Reading - 31,20 Western Coldarra Reading - 22,

   Reply
2. Doukora says:

   20.12.2019 at 07:33

   How to Read a Meter With Dials. RULE 1. If the arrow is between two numbers, always select the lower number, except when between 0 and 9. In that case, you'd select 9 since the 0 represents Rule 2. If the arrow is on a number. look at the dial to the right. If the right dial points to a number greater than 4, subtract 1.

   Reply
3. Yomuro says:

   16.12.2019 at 14:08

   May 14,  · The numbers you see followed by kWh is your meter reading; How to take a smart meter reading if your meter has 3 buttons. Press the button in the middle. Your meter reading is the number shown below IMP. If you have a two-rate meter, R1= Rate 1; R2 = Rate 2; T = total. You can see all readings by pressing the middle button again.

   Reply
4. Yozshujinn says:

   16.12.2019 at 20:50

   Apr 28,  · First, find the odometer on the water meter, then identify whether it is measured by gallons, imperial gallons, or cubic meters. Each part will have the different calculation to convert it into liters. Take the first reading and the end reading and subtract. Take the difference and convert it into gallons, imperial gallons, or cubic meters%(37).

   Reply
5. Kazraran says:

   15.12.2019 at 09:27

   Either ‘1’ or ‘2’ reading will be flashing – enter this one into the ‘Electricity (Day/Normal)’ box on the meter reading form. Then just enter the other into the ‘Electricity (Night/Low)’ box. Here, reading ‘1’ is and reading ‘2’ is Please note rate numbers can vary depending on .

   Reply
6. Nikojinn says:

   21.12.2019 at 22:32

   Apr 23,  · Smart meters with a Green button labelled 'A' Press the green button until you see ‘Total Act Import’. A reading should appear followed by ‘kWh’. For two rate meters or Economy 7 meters your meter will have a ’01’ and a ’02’ reading, which you’ll find by pressing the ‘A’ button.

   Reply
7. Kazitilar says:

   17.12.2019 at 12:08

   Dial meter. Each dial turns in the opposite direction to the one before it, so check which way each turns. Read the dials from left to right. Write down the number that the pointer has just passed e.g. if the pointer is between 2 and 3 write down 2. The reading for the above meter is

   Reply
8. Nemuro says:

   19.12.2019 at 03:47

   If you have an electricity single rate smart meter, the display will automatically show the reading. If you have an electricity dual rate smart meter, press and release the blue display button and this will show rate two. For gas smart meters, press and hold the red button A for 5 .

   Reply